How to check a mouse for unwanted double clicks
- Set the Double-click threshold, or keep the default of 80 ms.
- Select Start, or click in the Double-click test area to begin.
- Click one button at a time at a normal pace, 30 times or more, and repeat for each button you want to check.
- Select Stop and read Possible double clicks, Share of gaps and the histogram of gaps.
Why a mouse starts double clicking
A mouse button is a small switch. As it wears, its contacts can bounce, so one press reaches the computer as two presses a few milliseconds apart. You notice it as files opening when you meant to select them, or drag and drop that lets go too early. Mouse double clicking of this kind usually gets worse over time and often affects the left button first, because it is used most.
The test times every press of the five buttons the browser reports: left, middle, right, back and forward. It compares each press with the one before it on the same button. A gap under the threshold is listed as a possible double click, and the histogram shows all gaps from 0 to 500 ms in 10 ms steps with the threshold marked.
Reading the result
| Reading | What it means |
|---|---|
| 0 possible double clicks after 50 or more clicks | No sign of switch bounce in this run |
| A few gaps under 50 ms | Typical of a worn switch; repeat to confirm |
| Many gaps just under the threshold | You may be clicking fast; lower the threshold |
Change the threshold after you stop to see how the count changes. If one button shows short gaps and the others do not, the switch in that button is the likely cause. To check every button, the scroll wheel and wheel bounce in one place, use the mouse test. The keyboard test does the same for keys.
Frequently asked questions
What counts as a possible double click?
Two presses of the same button with a gap shorter than the threshold. A gap equal to the threshold does not count. Presses of different buttons are timed separately, so a left click followed by a right click is never counted.
Which threshold should I use?
Keep 80 ms for a first check. Most people cannot click the same button twice in under 80 ms on purpose, while a worn switch often bounces within 10 to 50 ms. Lower it toward 50 ms if you click very fast.
How many clicks do I need?
At least two presses of a button give one gap. A few dozen single clicks per button give a clearer picture, because a failing switch may misfire only now and then. The test keeps the last 5,000 presses.
Does a result prove the mouse is broken?
No. It shows the timing your browser received. Check that your system double click speed and any mouse software are not adding clicks, then repeat the test before deciding.
Why are the right-click menu and back button off in the area?
So those buttons can be tested without opening a menu or leaving the page. The right-click menu works as usual outside the area. Back and forward are blocked on this page while the test runs and work again after you stop.
Is the double click tester sending my clicks anywhere?
No. Presses are timed in this page and kept in memory only. Reloading the page clears them.
Last updated November 18, 2026